1个LED灯闪烁的Arduino控制

控制任务和要求

让一个LED灯闪烁

接线  

程序设计

 1 int half_cycle=1000;   // define the cycle time of LED blink
 2 int LED_pin=12;      // define the LED pin
 3 
 4 // the setup function runs once when you press reset or power the board
 5 void setup() 
 6 {
 7   pinMode(LED_pin, OUTPUT);    // initialize digital pin 13 as an output.
 8 }
 9 
10 // the loop function runs over and over again forever
11 void loop() 
12 {
13   digitalWrite(LED_pin, HIGH);     // turn the LED on (HIGH is the voltage level)
14   delay(half_cycle);              // wait for half_cycle time
15   digitalWrite(LED_pin, LOW);     // turn the LED off by making the voltage LOW
16   delay(half_cycle);              // wait for half_cycle time
17 }

注解

改变LED_pin的值可以改变LED的联接引脚，改变half_cycle的值可以改变闪烁周期。