开启远程访问h5菠菜平台开发Q2152876294 论坛：http://diguaym.com/forum.php
Redis安装完之后，在服务中可以看到对应的Redis服务，打开属性，可以看到“可执行文件的路径”是：”D:\Program Files\Redis\redis-server.exe” –service-run “D:\Program Files\Redis\redis.windows-service.conf”
开启Redis远程访问的步骤如下：
打开redis.windows-service.conf
找到“bind 127.0.0.1”并在前面加#注释
找到“protected-mode yes”并改为“protected-mode no”
配置如下：
################################## NETWORK #####################################
By default, if no "bind" configuration directive is specified, Redis listens
for connections from all the network interfaces available on the server.
It is possible to listen to just one or multiple selected interfaces using
the "bind" configuration directive, followed by one or more IP addresses.
#
Examples:
#
bind 192.168.1.100 10.0.0.1
bind 127.0.0.1 ::1
#
~ WARNING ~ If the computer running Redis is directly exposed to the
internet, binding to all the interfaces is dangerous and will expose the
instance to everybody on the internet. So by default we uncomment the
following bind directive, that will force Redis to listen only into
the IPv4 lookback interface address (this means Redis will be able to
accept connections only from clients running into the same computer it
is running).
#
IF YOU ARE SURE YOU WANT YOUR INSTANCE TO LISTEN TO ALL THE INTERFACES
JUST COMMENT THE FOLLOWING LINE.
~~~~~~~~~~~~~~~~
bind 127.0.0.1
Protected mode is a layer of security protection, in order to avoid that
Redis instances left open on the internet are accessed and exploited.
#
When protected mode is on and if:
#
1) The server is not binding explicitly to a set of addresses using the
"bind" directive.
2) No password is configured.
#
The server only accepts connections from clients connecting from the
IPv4 and IPv6 loopback addresses 127.0.0.1 and ::1, and from Unix domain
sockets.
#
By default protected mode is enabled. You should disable it only if
you are sure you want clients from other hosts to connect to Redis
even if no authentication is configured, nor a specific set of interfaces
are explicitly listed using the "bind" directive.
protected-mode no
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
解决的过程
由于百度得到的答案基本都是说把“bind 127.0.0.1”注释掉就可以了，根据配置文件的描述，也确实是要注释掉才可以被其他机器访问到，配置完重启，通过其他机器的redis-cli客户端进行连接，连接命令：redis-cli -h 172.16.8.200 -p 6379
意外的发现竟然连上了，于是随表敲一个命令，比如info，出现了如下提示：
这里写图片描述
通过阅读提示，在配置文件中找到protected-mode，并将其值改为no，重启之后，问题解决了。