【复现现象】
全志R18 Tina3.0 重启后开机卡死，reboot重启或者按 rese键重启，较大概率卡在这里
FAT: Misaligned buffer address (4ac89eb8)
no misc partition is found
set next system normal
NAND_UbootExit
NB1 : N[684]特别是烧写完之后第一次启动，几乎必现，具体log如下：
[684]HELLO! BOOT0 is starting!
[687]boot0 commit : a70c5bbb58695480b53507fd1f05a1b785c0038c
[725]special boot0, will not check key
[729]rsb_send_initseq: rsb clk 400Khz -> 3Mhz
[735]PMU: AXP81X
[737]set pll start
[742]set pll end
[743]rtc[3] value = 0x0000b00f
[746]DRAM driver version: V1.6
[749]the chip id is 0x000000bc
[752]the chip id is 0x000000bc
[755]the chip id is 0x000000bc
[758]the chip id is 0x000000bc
[761]the chip id is 0x000000bc
[764]DRAM Type = 3 (2:DDR2,3:DDR3,6:LPDDR2,7:LPDDR3)
[769]DRAM clk = 672 MHz
[772]DRAM zq value: 003b3bbb
[777]DRAM init OK
[779]DRAM size = 256 MB
[781]DRAM init ok
[783]dram size =256
[786]boot0:nand driver date:20171025
[789]NAND_ClkRequest, nand_index: 0x00000000
[793]Reg 0x01c20080: 0x80000000
[796]Reg 0x01c20060: 0x00006040
[799]Reg 0x01c202c0: 0x00006040
[802]NAND_SetClk, nand_index: 0x00000000
[806]Reg 0x01c20080: 0x80000000
[809]NB0 : nand phy init ok
[811]block from 2 to 41
[813]nand block 2 is bad
[816]load_toc1_from_nand err: the toc1 head magic is invalid
[822]nand block 4 is bad
[824]nand block 5 is bad
[827]nand block 6 is bad
[829]nand block 7 is bad
[832]current block is 8 and last block is 41.
[853]current block is 9 and last block is 41.
[873]current block is 10 and last block is 41.
[894]current block is 11 and last block is 41.
[915]current block is 12 and last block is 41.
[919]current block is 13 and last block is 41.
[940]current block is 14 and last block is 41.
[961]current block is 15 and last block is 41.
[982]current block is 16 and last block is 41.
[1043]The file stored in start block %u is perfect.
[1047]Entry_name = u-boot
[1054]Entry_name = monitor
[1058]Entry_name = scp
[1065]set arisc reset to de-assert state
[1068]Entry_name = logo
[1071]Entry_name = soc-cfg
[1074]Entry_name = dtb
[1077]Warning:can not find dtb--1 in toc1
[1080]default load dtb
[1083]Warning:can not find soc-cfg--1 in toc1
[1087]default load soc-cfg
[1090]Ready to disable icache.
*ｨ@=鈼 Configuring SPC Controller
INFO: sram test reg 0
NOTICE: BL3-1: v1.0(debug):fb15456
NOTICE: BL3-1: Built : 19:16:14, Dec 1 2017
NOTICE: BL3-1 commit: fb15456f8e4ddc7b0c7e45acc3fb3d1acf9775a8
INFO: BL3-1: Initializing runtime services
ERROR: Error initializing runtime service tspd_fast
INFO: BL3-1: Preparing for EL3 exit to normal world
INFO: BL3-1: Next image address = 0x4a000000
INFO: BL3-1: Next image spsr = 0x1d3
U-Boot 2014.07 (Sep 05 2018 - 18:23:59) Allwinner Technology
uboot commit : 6f335f96edbddb169d77be8a94757dfd6a3984f7
normal mode: with secure monitor
I2C: ready
rsb: secure monitor exist
[1.151]pmbus: ready
[SCP] :sunxi-arisc driver begin startup 2
[SCP] :arisc version: [sun8iw5_v0.03.00-399-g9fac845]
[SCP] :sunxi-arisc driver v1.10 is starting
boot0 probe pmu_type = 0x11
[1.191]PMU: cpux 1008 Mhz,AXI=336 Mhz
PLL6=600 Mhz,AHB1=150 Mhz, APB1=75Mhz AHB2=150Mhz MBus=400Mhz
DRAM: 256 MiB
Relocation Offset is: 05e04000
gic: sec monitor mode
[1.256]power on cpu1
[cpu1]Battery Voltage=0, Ratio=0
[cpu1]STATE_SHUTDOWN_CHARGE
[1.267]power on cpu2
workmode = 0,storage type = 0
[cpu2]bmp lzma decode err
[1.267]NAND: NAND_UbootInit
NAND_UbootInit start
NB1 : enter NAND_LogicInit
nand : get id number_ctl from script:0x55aaaa55
uboot: nand version: 3 5020 20180528 16891444
nand : get CapacityLevel from script, 55aaaa55
not burn nand partition table!
NB1 : nftl num: 1
init nftl: 0
NB1 : NAND_LogicInit ok, result = 0x0
NAND_UbootInit end: 0x0
reading ULI/factory/board_id.txt
** Unable to read file ULI/factory/board_id.txt **
-1 bytes read
Get boardid faile
check boardid faile,will used default soccfg and dtb!
get secure storage map err
sunxi secure storage is not supported
[1.565]usb burn from boot
delay time 0
[1.647]usb prepare ok
usb sof ok
[1.855]usb probe ok
[1.855]usb setup ok
set address 0x1e
set address 0x1e ok
[4.886]do_burn_from_boot usb : have no handshake
ab update mode
use bootA
use rootfsA
get secure storage map err
secure storage init fail
root_partition is rootfsA
--------fastboot partitions--------
-total partitions:9-
-name- -start- -size-
UDISK : 5740000 153bc00
env : 100000 100000
bootA : 200000 a00000
rootfsA : c00000 1e00000
bootB : 2a00000 a00000
rootfsB : 3400000 1e00000
rootfs_data : 5200000 400000
private : 5600000 100000
sgw_update : 5700000 40000
-----------------------------------
set root to /dev/nand0p4
reading ULI/factory/mac.txt
FAT: Misaligned buffer address (4ac89eb8)
no misc partition is found
set next system normal
NAND_UbootExit
NB1 : N[684]【解决方法】
这个问题是因为设备本身没有电池，但是sys_config.fex没有设置设备是不用电池的，开机的时候就会一直在找电池，但是又找不到，就一直卡在那里了，把设置设为不使用电池就行了，修改的方法如下：
