Problem Description
Since the Raspberry Pi 32G card used by TF last time, it is not enough for you to buy it after being kind. Today, I re-burned the image with a new 200G TF card, and after I inserted it into the Nano for the first time, I found it could not start and appeared
’A start job is running for end-user configureation after initial OEM installation‘
The question is shown below
Solution
Situation introduction: At that time, Nano was connected to the camera, and the display and the Nano board were powered separately.
Solution: Remove the camera , disconnect the Nano and restart it . problem solved.
Relevant information
After consulting related literature, two answers were found to be very related: