**
Recovery Actions of Cisco 2960 After Deleting Mirroring by Mistake
**
Case: I accidentally deleted the software image of the switch 2960, and the switch cannot be used after restarting
Solutions:
Download the image (.bin file) of the 2960 software from the official website, and upload the image to the switch through the serial port (the speed is extremely slow), it is recommended to find an old version first, and the image is as small as possible
Solution steps:
1. Enter the command: copy xmodem: flash:file_name.bin
switch: copy xmodem: flash:c2960-lanbasek9-mz.122-46.SE.bin
2. Use secureCRT to upload the software image by sending xmodem
3. Check whether the image is uploaded successfully
switch: dir flash:/
4. Restart the machine
switch: boot
Summary: If there is no error reported in the above steps, the image will be restored at this point. After the switch can be turned on, use tftp to upload the image of the software version you want to upgrade (this method is fast), and then upgrade