Problem Description:
How to quickly draw holes in a certain plane to dissipate heat and hollow them out?
Solution:
Use array operations.
1) Draw a circle and stretch it
2) Select the unit that needs to be arrayed, select the array operation, select the direction in the pop-up interface, select translation or rotation as needed, and select a translation axis or rotation axis (the rotation axis is X/Y/Z, etc. or a certain circle center axis ) , useful when creating circular arrays)
Set the number of array members and the spacing between arrays, and confirm completion
Note: When selecting the translation operation, and selecting two directions: the first direction and the two axes in the second direction, the entire plane of the array operation has four directions: upper left, lower left, upper right, and lower right. Array operations are required, but after the operation is completed After the first direction, repeated arrays will appear when executing the second direction, causing the interface to always perform array operations at the location where holes have been dug, causing the software to freeze.
The effect after the final array operation:
