Like the following scenario:
Basic configurations
First click on the upper left corner - New
Then we put to use the equipment up onto the panel
The finished product is this:
Click on the Add notes to them
Let's look at the configuration experiments addressing
Right-click the Settings PC1 (PC2 Similarly, not much demonstrates):
Click Start Select All
After the start, right-click the router, select cli enter.
2. Configure the IP address of the router
Then enter system-view The system view (if you do not use?, Too lazy to play so many characters to use Tab completion)
Then change the name -R1
Next we configure the router ip interface using the interface command to enter the corresponding interface view GE 0/0/0 Router
Configure the router interface IP address and subnet mask (FIG an order) in view router interface
After configuration, use display ip interface brief command to view the interface with the ip summary-related information (we can see that GE 0/0/0 interfaces ip has changed)
Similarly configure GE 0/0/1
So are we configured the
3. Check the router configuration information
May be IPv4 routing table information dispaly ip routing-table command
We saved what settings (user view retreated using the save command)
Next, we look at two hosts can not ping each other
that's it
We tried to capture a try
That's all (above I used the PC2 PC1 ping Kazakhstan)